Charging/Operating A Usb Device - Parkside PWCA 20-Li A1 Kurzanleitung

Charging/operating a USB device

NOTE
►
If only a small amount of current (< 130 mA) is
drawn, the battery adapter will switch itself off after
a short time. The charging or operation of such a
device is therefore not possible.
Connect your USB device to the USB port 8
♦
of the battery adapter 3.
Press the ON/OFF switch 6 to activate the battery
♦
adapter 3. The indicator LED 7 lights up continuously
to indicate the supply of power. Your device can now
be charged or operated on the battery adapter 3.
To turn off the USB port 8, press the ON/OFF
♦
switch 6 again for around two seconds.
The indicator LED 7 goes out after a short time.
♦
If you are no longer using or charging your device,
disconnect it from the battery adapter 3.
│ GB │ IE
■ 12 PWCA 20-Li A1