Mounting The Brush Cutter - Fuxtec FX-4MS131 Original Bedienungsanleitung

Original Bedienungsanleitung FX-4MS131_de_en_fr_ita_rev04

21. Mounting the brush cutter

Attaching the handle
The handle must be mounted before use.
For correct installation, follow the illustrations below.
Mounting the handle tube for use
Place cup B on the shaft tube, up and down, screw both cups and the shaft tube together.
Put the handle into the provided clamping bush, which is already attached to the shaft tube.
Now place the other shell on top and screw both half-shells and the grip tube together.
Please pay attention to the illustration "Components" to ensure that the handle is in the
correct position!
Mounting the drive axle
1). Place the drive axle against the main shaft so that the hole of
the axle is aligned with the locking bolt of the connecting piece.
2). Actuate the locking pin and insert the drive axle into the main
shaft. Release the locking pin and ensure that the locking pin
engages in the hole.
3). Turn the wing screw clockwise to secure the connection.