Fuxtec FX-4MS131 Original Bedienungsanleitung Seite 40

Original Bedienungsanleitung FX-4MS131_de_en_fr_ita_rev04
is necessary to replace the guard or cutting tool, be sure that the machine and cutting
tools have stopped.
⚫
The machine must be OFF before changing the machine's working range.
⚫
Please make sure that the nylon cutting head does not hit against stones or
other hard objects.
⚫
Please always make sure that screws have not become loose or that the machine
does not overheat.
⚫
If necessary, have the machine serviced by an authorized dealer. If the device is
defective, do not let it continue to run.
⚫
When starting or operating the machine, never touch hot parts like the exhaust, the
ignition cables, or the spark plug.
⚫
After the machine has stopped, the exhaust is still hot. Never place the device near
inflammable materials (dry grass, inflammable gases, or inflammable liquids, etc.).
⚫
Take special care that the ground can be slippery when operating the machine in the
rain or immediately after rain.
⚫
If you slip or fall to the ground, release the throttle immediately.
⚫
Be careful not to drop the machine or hit it against obstacles.
⚫
Before adjusting or repairing the machine, make sure that the device is stopped, and
the spark plug connector is removed.
⚫
If the machine is to be stored for an extended period, drain fuel from the fuel tank and
carburettor, clean the parts, place the device in a safe place and ensure that
the machine has cooled down completely.
⚫
Carry out constant checks to ensure safe and efficient operation. For a complete
inspection of your machine, please contact a specialist workshop.
⚫
Keep the machine away from fire or sparks.
⚫
Be careful when using it. There is a danger of kick-back and recoil.
⚫
Use extreme caution when using this machine with the cutting blade. A cutting blade
kick-back is a reaction that can occur when the rotating cutting blade hits an object
that cannot be cut. This contact causes the cutting knives to stop for a moment and
then suddenly push away from the hit object with accelerated force. This kick-back
reaction can be severe enough that the operator loses control of the machine. A
cutter blade kick-back can occur without warning if the cutter blade encounters an
obstacle, becomes blocked, or jams. This is more likely in areas where it is difficult to
see the material being cut. For easy and safe cutting, approach the weeds to be
mowed from your right to your left side. If an object or stick of wood is hit
unexpectedly, this can reduce a cutter blade kick-back.
40