Technical Data - Milwaukee M12 AF Originalbetriebsanleitung

TECHNICAL DATA

Type
Production code
Battery voltage
Rating current max.
Air delivery rate I
Air delivery rate II
Air delivery rate III
Weight according EPTA-Procedure 01/2014
(Li-Ion 2,0 Ah ... 6,0 Ah)
Recommended Ambient Operating Temperature
Recommended battery types
Recommended charger
WARNING! Read all safety warnings and all instructions. Failure to
follow the warnings and instructions may result in electric shock, fire
and/or serious injury.
Save all warnings and instructions for future reference.
BATTERY-POWERED FAN SAFETY WARNINGS
This appliance can be used by
children aged from 8 years and above
and persons with reduced physical,
sensory or mental capabilities or lack of
experience and knowledge if they have
been given supervision or instruction
concerning use of the appliance in a
safe way and understand the hazards
involved. Children shall not play with the
appliance.
Cleaning and user maintenance shall
not be made by children without
supervision.
Use the power pack supplied by the manufacturer.
Do not use the appliance near naked flames or glowing ashes.
Avoid dangerous environments. Do not use in rain, snow,
damp or wet locations. Do not use in the presence of explosive
atmospheres (gaseous fumes, dust or fammable materials)
because sparks may be generated when inserting or removing
battery pack, possibly causing fire.
Do not leave the appliance unsupervised when it is switched on.
Never close or block the air grille. DO not block the fan impeller.
Do not use the fan without the fan grille or if the fan grille is
defective.
Only use the appliance in a well ventilated area.
Dress properly. Do not wear loose clothing or jewellery, they can
be caught in moving parts. Loose clothing, jewels and long hair
may get caught by moving parts.
Exhausted batteries are to be removed from the appliance and
safely disposed of.
If the appliance is to be stored unused for a long period, the
batteries should be removed.
The supply terminals are not to be short-circuited.
Rechargeable batteries are to be removed from the appliance
before being charged; Non-rechargeable batteries are not to be
recharged.
12
M12 AF
Battery-powered fan
4832 35 01 XXXXXX MJJJJ
12 V ⎓
1,5 A
300 m 3 /h
450 m /h
3
680 m /h
3
2,2 ... 2,5 kg
-18 ... +40 °C
M12B...
C12C; M12C4; M12-18...
ADDITIONAL SAFETY AND WORKING INSTRUCTIONS
WARNING! To reduce the risk of fire, personal injury, and product
damage due to a short circuit, never immerse your tool, battery pack
or charger in fluid or allow a fluid to flow inside them. Corrosive or
conductive fluids, such as seawater, certain industrial chemicals,
and bleach or bleach containing products, etc., Can cause a short
circuit.
Never break open battery packs and chargers and store only in dry
rooms. Keep dry at all times.
Use only System M12 chargers for charging System M12 battery
packs. Do not use battery packs from other systems.
SPECIFIED CONDITIONS OF USE
This machine is intended for commercial use, for example in
hotels, schools, hospitals, factories, shops, offices and rental
businesses.
Do not use the product in any way other than those stated for
intended use.
RESIDUAL RISK
Even when the product is used as prescribed, it is still impossible
to completely eliminate certain residual risk factors. The following
hazards may arise in use and the operator should pay special
attention to avoid the following:
• Injury caused by vibration. Hold the product by designated
handles and restrict working time and exposure.
• Exposure to noise can cause hearing injury. Wear ear protection
and limit exposure.
• Injury due to flying debris Wear eye protection, heavy long
trousers, gloves and substancial footwear at all times.
• Inhalation of toxic dusts.
NOTES FOR LI-ION BATTERIES
Use of Li-Ion batteries
Battery packs which have not been used for some time should be
recharged before use.
Temperatures in excess of 50°C (122°F) reduce the performance of
the battery pack. Avoid extended exposure to heat or sunshine (risk
of overheating).
The contacts of chargers and battery packs must be kept clean.
For an optimum life-time, the battery packs have to be fully charged,
after use.
To obtain the longest possible battery life remove the battery pack
from the charger once it is fully charged.
For battery pack storage longer than 30 days:
Store the battery pack where the temperature is below 27°C and
away from moisture
Store the battery packs in a 30% - 50% charged condition
Every six months of storage, charge the pack as normal.
ENGLISH
Battery protection for Li-Ion batteries
In extremely high torque, binding, stalling and short circuit situations
that cause high current draw, the tool will vibrate for about 5
seconds, the fuel gauge will flash,and then the tool will turn OFF.
To reset, remove the battery pack from the tool and replace it. Under
extreme circumstances, the internal temperature of the battery pack
could raise too much. If this happens, the fuel gauge will flash until
the battery pack cooled down. After the lights go off, the work may
continue.
Transporting Lithium Batteries
Lithium-ion batteries are subject to the Dangerous Goods Legislation
requirements.
Transportation of those batteries has to be done in accordance with
local, national and international provisions and regulations.
The user can transport the batteries by road without further
requirements.
Commercial transport of Lithium-Ion batteries by third parties is
subject to Dangerous Goods regulations. Transport preparation and
transport are exclusively to be carried out by appropriately trained
persons and the process has to be accompanied by corresponding
experts.
When transporting batteries:
Ensure that battery contact terminals are protected and insulated to
prevent short circuit.
Ensure that battery pack is secured against movement within
packaging. Do not transport batteries that are cracked or leak.
Check with forwarding company for further advice.
CLEANING
The ventilation slots of the machine must be kept clear at all times.
MAINTENANCE
Use only Milwaukee accessories and Milwaukee spare parts. Should
components need to be replaced which have not been described,
please contact one of our Milwaukee service agents (see our list of
guarantee/service addresses).
If needed, an exploded view of the tool can be ordered. Please
state the Article No. as well as the machine type printed on
the label and order the drawing at your local service agents or
directly at: Techtronic Industries GmbH, Max-Eyth-Straße 10,
71364 Winnenden, Germany.
SYMBOLS
Please read the instructions carefully before starting
the machine.
CAUTION! WARNING! DANGER!
Remove the battery pack before starting any work on
the appliance.
This tool is only suitable for indoor use. Never expose
tool to rain.
Qualified for tropical climate up to 40°C ambient
temperature
Accessory - Not included in standard equipment,
available as an accessory.
Do not dispose electric tools, batteries/rechargeable
batteries together with household waste material.
Electric tools and batteries that have reached the end
of their life must be collected separately and returned
to an environmentally compatible recycling facility.
Check with your local authority or retailer for recycling
advice and collection point.
Class III tool.
V
Voltage
Direct Current
European Conformity Mark
British Conformity Mark
Ukraine Conformity Mark
EurAsian Conformity Mark
ENGLISH
13