Amitek AK940P Handbuch Zur Installation, Bedienung Und Wartung Seite 29


Confirm the new setting by pressing the S
ous operation. The newly set value will flash for 2 seconds to indicate the confirmation and
storage of the new data. The data is stored, even if no key is pressed for 15 seconds.
When running, the appliance will cool the cell until the currently set operating
temperature is reached. Once the set operating temperature is reached, the elec-
tronic control unit will turn off the cooling unit until the temperature detected by
the probe rises by about 4-5 degrees. When this happens, the control unit will
turn on the cooling unit to lower the temperature until it returns to the set oper-
ating temperature.
This "on-off" mechanism is perfectly normal and is common in all refrigeration
equipment such as refrigerated bars, cabinets, display cases, etc. Please note that
the temperature shown on the control unit display refers to the air temperature
(very susceptible to temperature changes due to the opening of the door) and not
to the temperature at the core of the appliance, which is much more constant
over time.
Error messages displayed on the control unit:
MESSAGE
P1
If one or more error codes are displayed, write them down, turn off the appliance then turn it back
on after 3-4 minutes. If one or more of the codes are again displayed, contact the dealer to request
technical support and inform them of the error codes.
Food storage
The following instructions should be followed in order for the appliance to perform at its best:

Put the food into the appliance after it has reached the desired temperature displayed on the
control unit. To avoid restricting air circulation, do not put too many products in the upper part
of the refrigerator and in the area near the technical compartment;

Do not place hot foods inside the appliance (they must be previously cooled in a blast chiller) or
in unclosed containers. Always package and protect foods before putting them in the refrigerator;

Position the food inside the appliance so that they do not obstruct the condensation water
drain hole, located on the bottom of the refrigerated cell (ref. Fig.1 - Section 8), and so that
they do not obstruct the normal flow of the condensation water towards the drain;

Avoid opening doors frequently and for extended periods of time, and wait at least 30 seconds
before re-opening the door.
Defrosting - Defrost timing (see Pic.3 - Section 8)
The control unit automatically performs 4 defrost cycles in a 24 hour period (once every 6 hours).
When the defrost cycle is active, the D
remains on. The timer begins from the moment the appliance was last turned on. To perform a
manual defrost cycle, just press the D
immediately begin. When finished, the defrost timer will reset itself so that no defrost cycles will be
performed for the next 6 hours. During manual defrost, the defrost light on the display will be on.
Defrosting water is collected in the condensation water collector tray.
TRANSLATION OF THE ITALIAN ORIGINAL INSTRUCTIONS
ERROR DESCRIPTION
Faulty thermostat probe
EFROST
EFROST
button within 10 seconds of completing the previ-
ET
EFFECT
The temperature is no longer being
adjusted correctly
LED on the control unit (LED no.1 - Pic.3 - Section 8)
button (D ) for 3 seconds and a defrost cycle will
EFROST
SOLUTION
Contact the dealer
- 29 -