Technical Data - EINHELL BG-EC 1840 TC Originalbetriebsanleitung

Anleitung_BG_EC_1840_TC_SPK1:_
Caution:
Make sure that the chain tension is always
correctly adjusted.
Only use a chainsaw if it is in perfect working
order.
Only work with a saw chain that has been
properly sharpened in accordance with the
instructions.
Never operate the saw above shoulder height.
Never cut with the upper edge or the tip of the
sword.
Always hold the chainsaw firmly with both hands.
Whenever possible, use the claw stop as a
leverage point.
Cutting wood which is under tension
Special care is required when cutting wood which is
under tension. Wood which is under tension from
which it is released by cutting may in some cases
react completely unpredictably and uncontrollably. In
the worst case this could result in extremely severe or
even fatal injuries (Fig. 22-24).
This type of work must only be performed by persons
who have been specially trained.

7. Technical data

Mains voltage:
Power rating:
Cutter rail length:
Cutting length, max.:
Cutting speed at rated rpm:
Oil tank capacity:
Weight with cutter rail and chain:
Protection class:
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L sound pressure level
pA
K uncertainty
pA
L sound power level
WA
K uncertainty
WA
19.12.2011 12:50 Uhr
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 60745.
Handle under load
Vibration emission value a
K uncertainty = 1,5 m/s
Additional information for electric power tools
Warning!
The specified vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equipment
is used and may exceed the specified value in
exceptional circumstances.
The specified vibration value can be used to compare
the equipment with other electric power tools.
The specified vibration value can be used for initial
assessment of a harmful effect.
Keep the noise emissions and vibrations to a
minimum.
Only use appliances which are in perfect working
order.
230-240 V ~ 50 Hz
Service and clean the appliance regularly.
1800 W
Adapt your working style to suit the appliance.
Do not overload the appliance.
400 mm
Have the appliance serviced whenever
375 mm
necessary.
13 m/s
Switch the appliance off when it is not in use.
Wear protective gloves.
120 ml
5 kg
Residual risks
II / ®
Even if you use this electric power tool in
accordance with instructions, certain residual
risks cannot be rules out. The following hazards
may arise in connection with the equipment's
construction and layout:
1. Lung damage if no suitable protective dust mask
is used.
2. Damage to hearing if no suitable ear protection is
used.
94 dB(A)
3. Health damage caused by hand-arm vibrations if
3 dB
the equipment is used over a prolonged period or
is not properly guided and maintained.
105 dB(A)
3 dB
Seite 21
= 6,99 m/s 2
h
2
GB
21