Waste Disposal; Cleaning And Maintenance; Ordering Replacement Parts - EINHELL 34.011.20 Gebrauchsanweisung

GB
spool mount tightly, press down the spool and
twist the depressed spool clockwise until it sits
securely.
Guide the line through one of the two slots in the
spool mount up to the edge of the guard hood
(Figure 7 and Figure 8).
The line will be cut to the correct length the first
time the cutting head is started (Figure 9).
Caution! Catapulted pieces of nylon line may
cause injury!
The following applies only to the ERT 250:
Hold the motor mount (D) tightly and twist the
spool mount (E) counter-clockwise until it can be
removed (Figure 16).
Replace the empty line spool with a full one.
Thread the end of the line through the holes in
the side of the spool (figure 17).
Place the spool mount on the motor mount, hold
the motor mount tightly, press down the spool
mount and twist it clockwise until it sits securely.
Press on the pushbutton and pull out line as far
as the edge of the guard hood (Figure 10).
The line will be cut to the correct length the first
time the cutting head is started (Figure 9).
Caution! Catapulted pieces of nylon line may
cause injury!

11. Cleaning and maintenance

Switch off and unplug the grass trimmer before
putting it away or cleaning it.
Remove deposits from the guard hood with a
brush.
Clean the plastic body and plastic parts with a
mild household detergent and a damp cloth.
Never use aggressive agents or solvents for
cleaning purposes!
Never spray down the grass trimmer with water.
Prevent water getting into the trimmer at all cost.

12. Ordering replacement parts

When ordering replacement parts, please quote the
following data:
Type of product
Article number of the product
ID number of the product
Number of the required replacement part
14

13. Waste disposal

Accessories and packaging should be recycled.
Plastic parts are marked for recycling in pure grades.