Ordering Replacement Parts; Care And Maintenance - EINHELL SB 401/1 Bedienungsanleitung

Anleitung SB 401-1-501-1 SKP 1
GB
material in question.
The table below acts as a guide for selecting the
proper speed for various materials.
Note: The drill speeds specified are merely
suggested values.
Drill bit Ø Cast iron Steel Iron Aluminium
3 2550 1600 2230 9500
4 1900 1200 1680 7200
5 1530 955 1340 5700
6 1270 800 1100 4800
7 1090 680 960 4100
8 960 600 840 3600
9 850 530 740 3200
10 765 480 670 2860
11 700 435 610 2600
12 640 400 560 2400
13 590 370 515 2200
14 545 340 480 2000
16 480 300 420 1800
18 425 265 370 1600
20 380 240 335 1400
22 350 220 305 1300
25 305 190 270 1150
7.11. Countersinking and center-drilling
With this table drill, you can also countersink and
center-drill. Please observe that countersinking
should be performed at the lowest speed, while a
high speed is required for center-drilling.

8.0. Care and maintenance

The table drill is to a large extent maintenance-free.
Keep the device clean.
Pull out the mains plug before doing any cleaning
and maintenance work on the machine.
Do not use any harsh, abrasive cleaning solvents.
Ensure that no liquid seeps into the device.
Regrease all bare parts when the work is finished.
The drill pillar, blank parts of the column, and the drill
table especially should be regreased at regular
intervals. Use a standard, acid-free lubricating
grease to do this.
Caution: Do not use your household refuse bin as a
receptacle for oil and grease-soaked cleaning rags or
grease and oil sludge. Dispose of these toxic
materials in an environmentally-friendly fashion.
Regularly check and clean the ventilation holes.
Store the device in a dry room. Should the device
become damaged, do not try to repair it yourself;
16
05.04.2004 11:47 Uhr
leave this work to the hands of a qualified electrical
technician.

9.0. Ordering replacement parts

Replacement parts can be ordered through ISC
GmbH (see the warranty declaration for the
Bronze
address). The following information should be
8000
provided when placing an order:
b Model/type of device
6000
b Item number of device
4800
b I.D. number of device
4000
b Number of the required replacement part
3400
3000
2650
2400
2170
2000
1840
1700
1500
1300
1200
1100
950
Seite 16