FEATURES
A. On/Off switch
B. LED Display
C. LED Charging Indicator
D. Removable Crevice Tool
E. suction Inlet
F.
Dust Bin Flap
G. Charger Base
STORAGE/CHARGING
Unit Storage
The product is designed to sit in the charging base on a flat surface or vertically if wall mounted. [1]
For tidy storage wrap excess cord on the back of the charging base and exit either side or bottom.
To Wall Mount (Tools required: Screwdriver and drill)
1. Place the cardboard ruler against the mounting surface. Mark the centres of the holes.
2. Move base then drill 4.8mm holes.
3. Fit wall plugs.
4. Position base into the insert screws, and move down to ensure the base is fixed firmly to the wall.
Charging & LED Indicator
Ensure the product on/off switch button is at the "OFF" position, then place the cleaner into the base, ensuring the shroud covers
the back of the product.
When the cleaner is charging, the charging LED indicator will flash to advise that the product is charging. When the product is fully
charged and is still positioned on the charger base, the icon will stop flashing and remain lit.
NOTE: Use only the charger supplied with your cleaner to recharge the unit.
IMPORTANT: When charging the appliance, the power switch must be off. Before using your cleaner for the first time, you must
fully charge it. This will take approximately 5 hours. Never charge the batteries in temperatures above 37°C or below 0°C. It is normal
for the charger to become warm to the touch when charging.
HOW TO USE
1. Remove the cleaner from the storage base.
2. Push the switch to 'ON' position to begin cleaning and to turn off move the switch to the 'OFF' position.
3. Empty and clean the unit and filter after each use.
4. To empty the bin pull the bin open trigger, the dust bin flap will open and stop about 45 °position for debris to empty easily. [2]
IMPORTANT: For best results clean the filter after each use.
LED DISPLAY
This cleaner is equipped with a LED display. When the product is on, the display will report following information:
Battery Level Indicator:
• 4 bars = 100% charge
• 3 bars = 75% charge
• 2 bars = 50% charge
ATTACHMENTS
Removable Crevice Tool
Fit the crevice tool onto the dust cup to clean corners and hard to reach areas. [3]
*certain models only
** May vary according to model
All manuals and user guides at all-guides.com
3
H. Cardboard Ruler
I.
Charger
J.
Dust Brush
K. Dust Bin Open Trigger
L. Flexible Hose*
M. Crevice Brush*
• 1 bar = 25% charge
• 0 bar <= 5% charge
GB