Electrolux DMGL8312AO Benutzerinformation Seite 25

Problem
The hood does not start
or turns off. The indica‐
tors above the hood con‐
trol symbols might also
blink.
The hood fan does not
work properly when the
hood functions are acti‐
vated.
The steam produced
during cooking is not suf‐
ficiently absorbed by the
hood.
and a number come
on.
Possible cause
The fan may turn off by it‐
self in certain conditions,
e.g. when the room is not
properly ventilated.
The ambient temperature
surrounding the hood is too
high.
There is insufficient air cir‐
culation inside and around
the hood.
The lids on the cookware
are not properly placed.
The hood filter is oversatu‐
rated.
There is an error in the
hob.
ENGLISH
Remedy
Open the window. You may
need to install the window
switch. Refer to "Assembly".
If the window switch is al‐
ready present, make sure it
was correctly installed. Refer
to the installation booklet.
Press any symbol. The hood
operates again.
Deactivate the hob and un‐
plug it from the main power
supply. Wait at least 10 sec‐
onds, then plug it in again.
Other suggestions:
Try to cool down the temper‐
ature of the surrounding
area. Take out the hood filter
and remove the residual
moisture from the inside of
the hood. Refer to "Care and
cleaning". Leave the hood
system to dry for one day,
then activate the hood again.
If your cookware does not
have vented lids, make sure
to tilt the lids so that the re‐
leased steam is directed to‐
wards the hood.
Refer to "Hints and Tips" for
information on the special
Steam Vented Lids recom‐
mended to be used with the
integrated hood.
Clean the hood filter and re‐
set the notification. Refer to
"Care and cleaning".
Deactivate the hob and acti‐
vate it again after 30 sec‐
onds. If comes on again,
disconnect the hob from the
electrical supply. After 30
seconds, connect the hob
again. If the problem contin‐
ues, speak to an Authorised
Service Centre.
25