Cleaning The Filter; Troubleshooting - Electrolux DMGL8312AO Benutzerinformation

4. Reassemble the filtering unit after
cleaning:
a. Slide the filter elements inside
the filter housing along the built-
in runners.
b. Place the filter housing back
inside the hood cavity.
Cleaning the filter housing
Wash the filter housing manually using a
mild detergent and a soft cloth. You can
also wash it in the dishwasher.

10. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
10.1 What to do if...
Problem
You cannot activate or
operate the hob.

Cleaning the filter

1. Wash the filter in warm water using a
2. Dry the filter in the oven for 20-30
3. Reassemble the filtering unit and put
4. If the notification
The counter restarts.
Possible cause
The hob is not connected
to an electrical supply or it
is connected incorrectly.
The fuse is blown.
You did not set the heat
setting for 60 seconds.
You touched 2 or more
sensor fields at the same
time.
Pause operates.
mild cleaning agent. You can use a
soft sponge, a soft cloth, or a non-
abrasive cleaning brush to remove
food remains, if necessary. You can
also wash the filter in a dishwasher at
65-70 °C (using a program longer
than 90 min), without dishes in the
same load.
min at 70 °C. Place the filter on the
middle wire shelf. Make sure to use a
non-fan oven function. Alternatively,
you can leave the filter to dry
overnight at room temperature. The
filter needs to be fully dried before
reassembly.
it back inside the hood cavity.
briefly to reset the counter.
Remedy
Check if the hob is correctly
connected to the electrical
supply.
Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali‐
fied electrician.
Activate the hob again and
set the heat setting in less
than 60 seconds.
Touch only one sensor field.
Refer to "Pause".
ENGLISH 23
is on, press