Conduct In Case Of Accident Or Failure; Conduct In The Case Of Blocked Saw Blade Due To Stuck Wood Pieces; Maintenance And Cleaning - ATIKA BTK Originalbetriebsanleitung, Sicherheitshinweise, Ersatzteile

Adjusting the cutting height on type BTH
The cutting height is adjusted with the handwheel (B). The cutting height
can be continuously adjusted as desired.
Connecting a chip extractor
Chip ejector slot closed (operation with chip extractor)
A chip extractor can be connected to the saw to extract the chips.
(Diameter of extractor nozzle: 100 mm.) Close the sealing blade on the
chip ejector slot and secure it using the machine knob.
Chip ejector slot open (operation without chip extractor)

Conduct in case of accident or failure

1. Press the red button on the ON/OFF switch.
2. Wait until the saw blade has come to a stop.
3. Disconnect the mains plug.
4. Initiate first aid actions in the event of injuries.
19
Conduct in the case of blocked saw blade due to
stuck wood pieces
1. Press the red button on the ON/OFF switch.
2. Disconnect the mains plug.
3. Remove the blockage.
Wear protective gloves.
Do not remove the stuck wood piece with your hands but using a
suited wood piece.
4. Check the saw blade for any damages.

Maintenance and cleaning

Before each maintenance and cleaning work
 Switch off device
 Wait unitl the saw blade comes to a stop.
 Pull out power plug
Maintenance and repair work other than those described in this chapter is
only allowed to be carried out by service staff.
For maintaining and cleaning, removed security devices must
unconditionally be mounted properly and proved again.
Use only original parts. Other parts can result in unexpected damages
and injuries.
Cleaning

Observe the following to maintain the operability of the machine:
 Do not wash down device with water.
 Remove shavings and dust only with a brush or vacuum cleaner.
 Regularly clean and oil all movable parts (e.g. fasteners of the
guard). Fig. 10

Never use any grease!

Use for instance sewing machine oil, liquid hydraulic fluid or
environmentally acceptable spray oil.
 Take care that the saw blade remain free of rust and resin.
 Resin residues must be removed from the table board.

Resin residues can be removed with a commercial
maintenance and care spray.
 The saw blade is a wearing part and will become dull after prolonged
or frequent use.

Renew the saw blade or have it sharpened.