Continuous Drainage - ProBreeze PB-15 Bedienungsanleitung

• When you remove the water tank, do not touch any parts inside the unit. Doing so may
damage the product.
• If there is water anywhere else in the unit when the water tank is removed, clean with a dry
cloth.
• Once connected, you can view performance and control your dehumidifier through the app.
Instructions
• If the unit is on and the water tank is full, the compressor and fan will turn off and the "full"
light will illuminate.
• To empty the water tank, slowly pull it out a little to loosen.
• Hold both sides of the water tank with two hands, and even strength, and pull it from the
unit. Do not put the water tank on the floor as the base is uneven.
• Throw the water away in a safe place and replace the water tank. Ensure this is done gently,
all the way into the unit, as forcing the water tank in may cause damage.

CONTINUOUS DRAINAGE

― ―
• Water can be automatically emptied into a floor drain or sink by attaching the unit to the
water hose (included).
• To do this, remove the plastic cover on the back of the unit. Caution: a small amount of
water may accumulate in the back drain outlet so have a small receptacle or dry cloth
ready to ensure this does not spill onto the floor.
• Attach the continuous hose cover and the drain hose to the back of the unit.
• Direct the hose to the drain; ensuring that there are no kinks and that the continuous hose
outlet is higher than the drain.
• Turn the unit on and press the "cont" button on the control panel.
NOTE: when the continuous drainage feature is not being used, remove the hose from the unit,
dry the outlet and replace the plastic cap.
English | 13 of 124