Controller Features; Manual Control - AquaForte DM-VARIO-Serie Bedienungsanleitung

OPERATING INSTRUCTIONS:
When use the pump, please pay attention to the position of the pump. Please connect the pump supply after finishing the
installation. If the pump can't pump the water out for the first time which may be caused by the air in the pump body. Please try
to plug off and re-plug on to vent the air. To ensure safety, please install a leakage switch with leakage current less than 30mA
when using outdoor (the leakage switch shall be installed by the user self).
CAUTION:
• Always disconnect the pump from the power supply before cleaning, maintenance and handling.
• Try to avoid the pump dry working.
• Do not lift the pump by holding the power cord only. In case of the cable connection off inside of the pump
• Do not use the pump in the heating liquid.
• The pump can't be used in the swimming pool.
• This product has multiple protection functions. When it enters the protection state, please plug off and plug on to recover
the pump normal work.

3. CONTROLLER FEATURES:

• Adjustable flow rate and head max.
• "Feed" mode, Pause, Timing, delay, WiFi, Restart function.
• Memory function, ensuring that the pump rework while keeping the same parameter.
WiFi status LEDs
Operation Function:
LED display screen
Pause button Flow DOWN
WiFi / START/STOP button Flow UP
Controller panel

3.1 Manual control

After connecting with pump, the controller is set per last operation, display shows normal locking panel. "P XXX" is shown in
display, where "P" is short for "Power", and "XXX" is the actual power consumption in watts (85 watt in the example). When you
touch the " / " buttons, the display will show the flow in %, which can be set from 30 to 100%. When you touch the "II"
(pause) button, the display shows "c 001", the pump stops working for the amount of minutes that is shown in the display (1
minute in this example). You can adjust the Pause time using the APP. After the pause time is finished the pump will resume
working. If you press the "II" button during the Pause time it will stop "Pause" mode and the pump will resume working. When
you touch the " " button, the pump stops and the display shows "OFF", touch " " again to start the pump again.
Remarks: When the pump enters to the timer mode set by APP, the LED will display as P.XXX. Push both " " buttons to exit
the timer mode.
3
VERSION 1.01 12/2022 AQUAFORTE DM-VARIO WIFI PUMP