Pump Control - AquaForte DM-VARIO-Serie Bedienungsanleitung

5. Wait for the device to connect, and tap the device to enter the control interface
Notice:
1. You may be asked to restart configuration process all over again if the WiFi pass-
word input is incorrect.
2. Make sure the device, mobile phone and router are placed as close as possible.
3. AP direct connection is only suitable for temporary control of the device in a non-
WiFi environment. (Manual calibration time is required when the equipment is
directly connected to AP after delivery. See V.4 Pump Management for detail.)

5.4 Pump control

After adding the pump device successfully, long press the pump icon for 2 seconds to enter the pump control page.
1. Manual mode:
Drag the arc progress bar to change the flow value of the pump. The minimum flow is 30% and the maximum is 100%.
Hold the icon for 2 seconds Manual control bar
ON/OFF
Current flow value
Pause icon
Program icon
VERSION 1.01 12/2022 AQUAFORTE DM-VARIO WIFI PUMP
11