Map Editing function
This function allows you to edit generated maps: rename cleaning areas, split or combine
areas, and edit cleaning mode, suction power, and scrubbing level in each selected area.
Robot vacuum cleaner's Location function
Allows to locate the robot vacuum cleaner on the map.
4. CLEANING AND MAINTENANCE
Main brush cleaning
The main brush rotates at high speed and helps pushing the dirt into the suction channel.
This brush is in contact with the floor, and therefore with dirt, so it can be worn out over time,
negatively affecting cleaning efficiency. For this reason, it is suggested to replace the main
brush after a maximum of 320 hours or less.
1.
Slightly press the main brush frame's tabs to open the main brush compartment and
remove it. Fig. 10
2.
Remove hair, lint, and other dirt trapped in the brush and around the shafts with the help
of the self-cleaning brush. Fig. 11
3.
Clear and clean the robot vacuum cleaner's suction channel.
4.
Reinstall the main brush and its frame.
Recommendation
It is recommended to clean the main brush once a week with the help of the self-cleaning
brush.
Side brushes. Fig. 12
Side brushes are designed with multiple bristles and are used to push dirt towards the suction
mouth and to thoroughly clean edges and corners. These brushes can wear out over time,
negatively affecting cleaning efficiency.
Recommendation
-
It is recommended to clean the side brushes once a week with the help of the self-cleaning
brush.
-
Remove the side brushes by pulling them outwards and clean them regularly.
Recommendation
In order to ensure a perfect cleaning, it is suggested to replace the side brushes every 3
months, depending on the frequency and type of use.
Mixed tank. Fig. 13:
-
Take the Wet & dry tank out.
ENGLISH
CONGA 7290 ETERNAL HOME X-TREME
59