Temperature Settings; Control Panel; Display Window - Fulgor Milano FWC 4500 TCFO Anleitung Zur Installation

TYPES OF REGULATION
Please note that depending on the loading and settings
chosen it takes about 24 hours for the wine cellar to see the
temperature stabilizing.
During this time LED seems to move erratically in particular,It
is normal and this process occurs whenever the setting is
modified and/or whenever a large amount of bottles are
added to the cellar.
Designed to store and mature all wines: red, white and
sparkling. These wine cellars reproduce the ideal conditions
for wine storage, at a constant recommended temperature
of 12ºC. They can also be set to provide ideal serving
temperature for full enjoyment of the wine's qualities. Unless
stated by the wine maker on the bottle, We recommends
7ºC for your champagne, 12ºC for whites and 18ºC for
reds. (Refer to "Wine Service Temperature" recommendation
chart).

TEMPERATURE SETTINGS

IMPORTANT
The LED displays by default the actual internal
air temperature.
The temperature of the power, before all Settings will be
resumed after the electricity to power the preset temperature
The electrical board of all models comes with memory
function.
It is important to understand that there is a difference
between the air temperature inside the wine cellar and
the actual temperature of the wine: You will need to wait
approximately 12 hours before noticing the effects of
temperature adjustment due to the critical mass within a full
wine cellar.
Once the temperature is set, it is strongly advised not to toy
with it or adjust frequently. The thermostat will maintain the
temperature inside the wine cellar within a +/- 2.5ºC range.
But the thermal inertia of the wine and the glass is such that
within this temperature range, the actual temperature of the
wine will only fluctuate 0.5ºC to 1ºC.

CONTROL PANEL:

3
1 2
From left to right:
• 1 Display Window:
Display the measured temperature inside the wine cooler;
• 2 Cycle Button:
Each time, the temperature inside will drop 1˚C, until
reduced to a minimum, and then a return to the highest
temperature.
Press for 3 seconds, the window to achieve Celsius /
Fahrenheit display conversion
• 3 Cycle Button:
In standby mode: press and hold for 3 seconds, power is
turned on, the machine starts
In the boot state: short press this button, LED lights on / off
switch
In the boot state: press the button for 3 seconds, the power
is off, the whole machine is closed.
1 2
EN
9