Wall Mounting - Stanley FATMAX V20 LITHIUM ION SFMCD700 Bersetzt Von Den Originalanweisungen

ENGLISH
Warning! Do not charge the battery at ambient temperatures
below 10 °C or above 40 °C. Recommended charging
temperature: approx. 24 °C.
To ensure maximum performance and life of lithium-ion
Plug the charger (9) into an appropriate outlet before
inserting battery pack (6).
The green charging light (9a) will blink continuously
indicating that the charging process has started.
The completion of charge will be indicated by the green
charging light (9a) remaining ON continuously. The battery
pack (6) is fully charged and may be removed and used at
this time or left in the charger (9).
Charge discharged batteries within 1 week. Battery life will
be greatly diminished if stored in a discharged state.
Green LED Intermittent
Green LED Solid
Green LED Intermittent
Red LED Solid
8
(Original instructions)
The compatible charger(s) will not charge a faulty
battery pack. The charger will indicate a faulty battery pack by
refusing to light.
This could also mean a problem with a charger. If the
charger indicates a problem, take the charger and battery
pack to be tested at an authorized service centre.
The charger and battery pack can be left connected with the
pack fresh and fully charged.
Hot/Cold Pack Delay
When the charger detects a battery that is too hot or too cold,
it automatically starts a Hot/Cold Pack Delay, the green LED
on continuously, suspending charging until the battery has
reached an appropriate temperature. The charger then
automatically switches to the pack charging mode. This
feature ensures maximum battery life.

Wall Mounting

Some STANLEY FATMAX chargers are designed to be wall
mountable or to sit upright on a table or work surface. If wall
mounting, locate the charger within reach of an electrical out-
let, and away from a corner or other obstructions which may
for the location of the mounting screws on the wall. Mount the
charger securely using drywall screws (purchased separately)
at least 25.4 mm long, with a screw head diameter of 7–9 mm,
screwed into wood to an optimal depth leaving approximately
5.5 mm of the screw exposed. Align the slots on the back of
the charger with the exposed screws and fully engage them
in the slots.
Do not attempt to mount SFMCB10 charger under a
bench or table.
Only mount SFMCB10 charger with the charging lights
pointed upward toward the ceiling.
The battery includes a state of charge indicator to quickly
pressing the state of charge button (6a) you can easily view
tool
Warning! Make certain the lock-off button is engaged to
prevent switch actuation before removing or installing battery.