must be in room temperature.
2.
Place the water tank again in the low body and carefully slide it in place.
3.
Remove the power cord and introduce it in a 120 V power socket.
4.
The indicator light will turn on when the steam cleaner is ready to be used. Press the
steam level button to choose the desired steam level.
Note
After the first use or after filling the water tank, the pump can produce a sound. This is normal
and it should last at least some seconds.
Before cleaning
Sweep or vacuum the floor thoroughly before cleaning with the steam cleaner.
Hard floors cleaning
Your steam cleaner is designed to clean hard floors, like ceramic tile, vinyl, laminate, marble,
stone and sealed hardwood floors. The use of the steam cleaner on waxed or unwaxed floors
may result in a decrease in gloss. You must use the steam cleaner first in an inconspicuous
area. Check the care instructions of the manufacturer of your floor.
1. Connect the unit and wait for 30 seconds for it to heat up. Choose the steam level to clean
the floor: Low (delicate floors), Medium (regular cleaning) and High (resistant or sticky
floors). Start cleaning by sliding the unit carefully over the floor surface. Fig. 7
Note
Press the On button and then the steam control button. Take into account that, when pressing
the steam level button for the first time, steam will be in the maximum level. Set the desired
level by pressing the steam control button.
2. To turn off the steam cleaner, press the steam level button until the blue light on the
button is on.
3. When the steam cleaner stops emitting steam, unplug the unit. Remove the water tank,
refill it and continue cleaning.
Note
Make sure to disinfect the floor, use a microfibre cloth and rub the floor back and forth at
least three times with continuous steam. For better results, remove the pad and wash it after
cleaning.
Sliding carpet
This accessory is installed in the mop head to allow the device to slide over carpets while
cleaning them. Fig. 8
CONGA HYDROSTEAM 3030 ACTIVE
ENGLISH
29