6�2�2 Welding Stud Holder Adjustment With Ceramic Ferrule - GYS ARCPULL 350 Benutzerhandbuch

Operating manual
6.2.1. WELDING STUD DOOR ADJUSTMENT WITHOUT CERAMIC FERRULE
The adjustment of the stud holder explained below is applicable for any added part except for those welded under pro-
tection by ceramic ferrule (075979), as well as extraction rods for rivets (see §6.4 and §6.5 ).
Set screw
1) Unscrew the lock nut of the stud holder adjustment screw.
2) Insert the insert into the stud holder and adjust the screw so that the end of the insert protrudes 5mm from the stud
holder.
3) Tighten the lock nut.
Note: If the insert weld has stud holder marks at the weld, adjust
the stud holder screw to push the insert out of the stud
holder a little more.
6.2.2. WELDING STUD HOLDER ADJUSTMENT WITH CERAMIC FERRULE
Set screw
1) Unscrew the lock nut of the stud holder adjustment screw.
2) Insert the insert into the stud holder and adjust the screw so that the end of the insert protrudes at least 15 mm from
the stud holder.
3) Tighten the lock nut.
6.3. USING THE PULL RING ATTACHMENT (059610)
Slightly unscrew the knurled nut (n°2 - Fig 2) from
the gun drive shaft.
Position the ring carrier as far as it will go and tighten
the knurled nut.
46
Translation of the original
instructions
Versus-
nut
Markings
Versus-
nut
ARCPULL 350
5mm
15mm