Noise/Vibration Information - Bosch EasyHedgeCut 45 Originalbetriebsanleitung

Hedgecutter
Tooth opening
Weight according to
EPTA‑Procedure 01:2014
Protection class
Serial number
Hedgecutter
Article number
Rated power input
No-load stroke speed
Cutting length
Tooth opening
Weight according to EPTA‑Pro-
cedure 01:2014
Protection class
Serial number
The specifications apply to a rated voltage [U] of 230 V. These specifications may vary at different voltages and in country-specific models.

Noise/Vibration Information

That the declared vibration total value(s) and the declared
noise emission value(s) have been measured in accordance
with a standard test method and may be used for comparing
one machine with another.
That the declared vibration total value(s) and the declared
noise emission value(s) may also be used in a preliminary as-
sessment of exposure.
That the vibration and noise emissions during actual use of
the machine can differ from the declared total value depend-
ing on the ways in which the machine is used; and of the
need to identify safety measures to protect the operator that
are based on an estimation of exposure in the actual condi-
tions of use (taking account of all parts of the operating cycle
such as the times when the machine is switched off and
when it is running idle in addition to the trigger time).
Noise emission values determined according to EN
62841-4-2:2019 .
Typically the A-weighted noise levels of the product are:
Sound pressure level 84 dB(A); sound power level
95 dB(A). Uncertainty K = 2.0 dB.
Wear hearing protection!
Vibration total values a (triax vector sum) and uncertainty K
h
determined according to EN 62841-4-2:2019:
2 2
a = 2.5 m/s , K = 1.5 m/s .
h
Troubleshooting
Bosch Power Tools
EasyHedgeCut 45
mm 16
kg 2.6
/ II
EasyHedgeCut 55
3 600 H47 C..
W
-1
min
cm
mm
kg
Operation
Pay attention to the mains voltage. The voltage of the
u
power source must match the voltage specified on the
rating plate of the machine.
Switching ON/OFF (see figures C and D)
To operate the machine, pull front trigger (3) and rear trig-
ger (2) together.
To switch off the machine, either release rear trigger (2) or
front trigger (3) or both at the same time.
Working with the Hedgecutter (see figure E)
Move the hedgecutter evenly forward along the cutting line.
The double edge cutting blade enables cutting in either dir-
ection, or with a side to side motion.
Cut the sides of the hedge first, then the top.
To cut the sides straightly, we recommend cutting from bot-
tom to top in the direction of growth. Younger stems tend to
move outwards when cutting them from top to bottom, res-
ulting in shallow patches or holes in the hedge.
To reach a level finish, fasten a piece of string along the
length of the hedge at the required height and use as an
alignment guide. Cut the hedge just above the string.
Pay attention that no objects such as wires are cut. The
blade or drive can be damaged.
English | 13
EasyHedgeCut 46 EasyHedgeCut 50
16
2.6
/ II
see type plate on garden tool
EasyHedgeCut 60
3 600 H47 D..
450
3400
55
16
2.8
/ II
see type plate on garden tool
F 016 L94 433 | (10.05.2023)
16
2.7
/ II
450
3400
60
16
2.8
/ II