Commissioning; Maintenance, Overhaul, Repair; Maintenance; Overhaul - Stahl 8146/1 Serie Betriebsanleitung

Commissioning

DE
7 Commissioning
EN
Before commissioning, carry out the following checks:
FR
▶
Check the device for damage.
▶
IT
Check whether mounting and installation have been performed correctly. When doing so,
check whether all coverings and partitions for live components have been installed and
ES
fastened.
RU
▶
Make sure that all openings/drilled holes in the enclosure are sealed with permissible
NL components. Dust and transport protection (adhesive tape or plastic caps) fitted at the
factory must be replaced with corresponding certified components.
DK
▶
Ensure that seals and seal systems are clean and undamaged.
SE
▶
Remove any foreign objects.
▶
If necessary, clean the connection chamber.
FI
▶
Check whether all the specified tightening torques have been observed.
PT
GR
8

Maintenance, Overhaul, Repair

PL
▶
Observe the relevant national standards and regulations in the country of use,
CZ
e.g. IEC/EN 60079-14, IEC/EN 60079-17, IEC/EN 60079-19.
SK
8.1

Maintenance

HU
Check the following points in addition to the national regulations:
SL
• Whether the clamping screws holding the electrical lines fit securely
• Whether the device has cracks or other visible signs of damage
RO
• Whether the permissible temperatures are complied with
BG
• Whether the parts are securely fitted
LV
• Ensure it is being used as intended.
LT
8.2

Overhaul

EE
▶
Perform overhaul of the device according to the applicable national regulations and the
CH
safety notes in these operating instructions ("Safety" chapter).
KR
8.3

Repair

CN
▶
Perform repairs to the device only with original spare parts and after consultation with
R. STAHL.
20
Terminal boxes
Series 8146/1,
Series 8146/2
137189 / 8146619300
2023-02-27·BA00·III·en·10