Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
All manuals and user guides at all-guides.com
Cleaning
Cooker hood
Clean the cooker hood with soapy water, then
wipe with clean water to rinse. Do not use
aggressive cleaning agents such as soda. The
cooker hood paintwork will stay looking nice if
you wax it occasionally.
Filters
Wash aluminium filters, every week in
soapy water. The cleaning agents will
make the aluminium filter turn dull, this is
normal.
Some models are fitted with fibre filters.
These can only be washed once or twice
and must therefore be replaced regularly.
The carbon filters cannot be cleaned to use
again.
General
This appliance should be connected to the
power supply by a recognized fitter who is
familiar with, and works according to the
correct safety regulations.
Important that you know
If the cooker hood is to be fitted to an
existing duct no other appliances, such as
a geyser or heater, may be connected to
that same duct.
Consider local regulations with respect to
the ventilation of gas appliances!
The cooker hood should be mounted at
least 650 mm above the hob.
The shorter the duct, and the fewer the
bends in it, the better the cooker hood will
work.
Before you start drilling check that there
are no installation cables present.
Cooker hoods with a visor
Mounting the cooker hood
H
G
Fig. 6. Mounting
Drill 4 holes in the bottom of the wall
cupboard, using the stencil provided (H). Also
saw the hole for the duct.
Using the 4 screws supplied, fix the cooker
hood to the bottom of the cupboard. Make
sure that the front of the cooker hood does not
stick out in front of the side of the
cupboard (G).
The handle may be replaced by other material,
e.g. the same material used for the kitchen
cupboards or the light strip. The handle is
fitted from the back with screws.
Werbung
Inhaltsverzeichnis
