Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
LED indicator / Beeper
The LED indicators and beeper become activated when the tool works in the following operating conditions and
notify you of the tool status and performance currently delivered on the control panel.
► Fig.7: 1. LED indicator A (in green, red, blue and yellow colors) 2. LED indicator B (in blue color) (* Not serve as
indicator for this model) 3. Error code 4. Status symbol
Error code
Tool performance
and status
and function
symbol on
screen
-
Operation check for
indicators and beeper
E00
Accidental start
prevention
E01
Auto-stop
E02
Anti-reset of controller The battery voltage drops
E03
Auto-stop for low
remaining battery
power
E04
Overload protection
E05
Overheat protection
E06
Motor lock
E07
Motor or controller
failure detection
E09
Torque sensor failure
detection
-
Auto-stop with fasten-
ing completion
Tool status
The tool starts to verify indica-
tors and beeper operation soon
after the battery cartridge is
installed.
The tool automatically stops
to avoid unintentional start-up
when the battery cartridge is
installed with the switch trigger
pulled.
The battery power becomes
low and it is time to replace the
battery cartridge.
abnormally for some reason,
and the tool automatically stops
operation.
The battery power is almost
used up, and the tool automati-
cally stops operation.
The tool automatically stops to
protect against a continuous
overcurrent.
The motor or controller gen-
erates excessive heat, and
the tool stops automatically to
protect the tool from damage.
Motor lock has occurred, and
the tool automatically stops the
motor operation.
Motor or controller failure has
been detected, and the tool
automatically stops the motor
operation.
The torque sensor cannot
be monitored properly for a
number of technical reasons
including line breaks.
The tool automatically stops the
motor operation after the pre-
set fastening steps have been
completed.
9 ENGLISH
LED indicators/beeper status
LED indicators
Beeper
The LED indicator
A series of
briefly lights up
very short
in green, red and
beeps
blue in order, and
then the front
lamp lights up.
The LED indicator
A series
flashes in red and
of short
green alternately.
beeps
The LED indicator
A series
flashes in red and
of short
green alternately.
beeps
The LED indicator
A series
flashes in red and
of short
green alternately.
beeps
The LED indicator
A long
lights up in red.
beep
The LED indicator
A series
flashes in red and
of short
green alternately.
beeps
The LED indicator
A series
briefly flashes
of short
in red.
beeps
The LED indicator
A series
flashes in red and
of short
green alternately.
beeps
The LED indicator
A series
flashes in red and
of short
green alternately.
beeps
The LED indicator
A series
flashes in red and
of short
green alternately.
beeps
The LED indicator
-
lights up in green
for approximately
one second.
Action to be taken
-
Release the switch
trigger.
Replace the battery
with fully charged
one.
Replace the battery
with fully charged
one.
Replace the battery
with fully charged
one.
Remove the cause
of overload and
restart the tool. If
no improvement
is found, ask your
local Makita Service
Center for repair.
Remove the battery
cartridge immedi-
ately and cool the
tool down.
Release the switch
trigger and pull it
again.
Ask your local
Makita Service
Center for repair.
Remove the battery
cartridge and cool
the tool down. If the
indicator remains lit,
ask your local Makita
Service Center for
repair.
-
Werbung
Inhaltsverzeichnis
