Setting The Ring Tone - m-e Bell-556 TX Betriebs- Und Montageanleitung

GB
Bell-556 TX

SETTING THE RING TONE

The ring tone is selected with the code/melody button (4). To change the
tones, press the button briefly and the radio chime will play a different
melody. Wait until the melody has been played completely. Then repeat the
process until you hear the desired melody. The last melody played is
GB
automatically saved and will be played from now on when the bell rings.
Note: With the selector switch (2) 8 further tones can be selected. However,
this only works with receivers from the BELL-500 series, such as the BELL-510
RX. For all models of the BELL-200 series, the switch must be in position "A",
otherwise no melody will be played on the radio chime receiver!
A B
24