Eneo VKC-1334/W3 Installation Und Betriebsanleitung Seite 30

• Main Menu - D&N
Press the MENU button to access the D&N mode.
Move up and down
Using the Tele & Wide
button
Your camera provides automatic mode changeover by CDS sensing day or night conditions. It changes to colour mode
in day condition for optimal colour and to BW mode in night condition for clear identification.
1. Press the SET button to display the MENU and move the indicator to D&N MODE using the LEFT or RIGHT
button.
2. Set D&N MODE to the desired mode using LEFT or RIGHT button
• AUTO (CDS or AGC): DAY & NIGHT AUTO Mode
DAY: Only Day
NIGHT: Only Night
EXT: External Interface (IR LED)
3. Set LEVEL to the desired mode using LEFT or RIGHT button
• AUTO AGC TYPE
LEVEL 1: Dark
LEVEL 2: Normal
LEVEL 3: Bright
* AGC LEVEL FIX
• AUTO CDS SENSOR TYPE
LEVEL 1: Day –> Night: 21Lux, Night –> Day: 80Lux
LEVEL 2: Day –> Night: 10Lux, Night –> Day: 21Lux
LEVEL 3: Day –> Night: 8Lux, Night –> Day: 14Lux
LEVEL 4: Day –> Night: 5Lux, Night –> Day: 10Lux
LEVEL 5: Day –> Night: 2Lux, Night –> Day: 4Lux
* Please set up the level higher whem you install this camera into the housing. (Level 5 is recommended)
4. Set FILTER DLY to the desired mode using LEFT or RIGHT button
• According to user's need, the turning delay time of 0 ~ 15 seconds can be given.
5. INITIAL
• Initializing D&N MODE
6. EXIT
• Return to MAIN MENU
D & N
D/N MODE
LEVEL
FILTER DLY
INITIAL
EXIT
30
AUTO
2
10
ON
Can be changed
using the NEAR &
FAR button