Manual Mode - Beyerdynamic MCW DIGITAL Bedienungsanleitung

Top View MCW-D 1043 Chairman Microphone Unit
(6)
(5)
(7)
(11)
(12)
(9) (10)
(8)
Important
• Remove the transportation protection (a piece of cardboard) from the charging compartment of each microphone unit before use.
When the unit is transported again, replace the transportation protection.
• To avoid overstretching and premature wear and tear, always adjust the gooseneck microphone via the lower flexible
part of the microphone and never the microphone head or rigid tube. The gooseneck can only be bent 90° at maximum.
3.2 Setting up
The microphone units have no separate on/off switch. They are switched on and off with the microphone button. By pressing
the button briefly, the microphone unit is switched on. The LED (7) flashes for a moment and the LED (2) on the rear is illuminated.
By pressing the button for more than 2 seconds the microphone unit is switched off and the LED (7) will illuminate twice orange
briefly. Using the controller software (standby button) the microphone unit can be switched off via the control unit. Furthermore, the
microphone units are switched off automatically, when they do not receive a data signal from the control unit for more than one
minute.
Important:
If the microphone unit is out of range of the MCW-D 100 control unit the LED (7) will flash red. After one minute the microphone
unit will switch off automatically.
3.2.1 Switching on
Switch on the microphone unit by pressing the microphone button briefly. The green operating control LED (2) on the rear will
illuminate.
The microphone units have an integrated rechargeable battery allowing an operating time of at least 10 hours in conference mode.
As soon as the capacity is too low for satisfactory operation, the operating control LED (2) will flash. The remaining time of
operation is around 30 minutes. The decreasing battery voltage is also signaled by the MCW-D 100 control unit at the RS 232 socket
and can be evaluated by an external media control system.
3.2.2

Manual Mode

Press the microphone button (8) to switch the gooseneck microphone on or off.
The LED (7) is illuminated green:
Red ring of the gooseneck
microphone is illuminated:
Using the standard version of the MCW-D 100 control unit 3 delegates and 1 chairman can speak simultaneously. Using
additional PCBs inside the MCW-D 100 up to 6 delegates and 1 chairman can speak simultaneously.
Important:
If the number of open microphones is reached, a microphone can only be switched on manually when another
microphone unit has been switched off.
(5) Gooseneck microphone with illuminated ring
(6) Loudspeaker
(7) LED to indicate the function (green / red)
(8) Microphone button
(9) Clear button for clearing the delegate microphone units
(10) Function button for optional functions
(11) LC-Display
(12) Buttons for adjustments (refer to chapter 3.2.5)
The integrated transmitter is adjusted to a free frequency and switched on.
The microphone is ready for talking.
29