Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1.2 Setting up
1. Place the MCW-D 100 control unit in the same room as the transmitters.
2. Do not place the MCW-D 100 control unit near digitally controlled equipment.
3. Connect the receiving antennae to the antenna inputs A and B (5) using the appropriate adapter. For stand-alone-operation we
recommend using the CA 2411 angled rod antenna and the CA 2444 N(HF) Male - SMA Female adapter.
4. Connect the transmitting antenna to the antenna output (12). For stand-alone-operation we recommend using the CA 2411
angled rod antenna and the CA 2444 N(HF) Male - SMA Female adapter.
5. There must be an unobstructed path between the microphone units and the antennae. The range is around 50 m. For
optimum range the surface of the table is important, wood or plastic tables are ideal, but metal tables can cause interferences
and reduce the range.
6. Connect the XLR (10) or RCA (14) master output to the input of a mixing console/amplifier.
7. Connect the MCW-D 100 control unit to the mains (7). The internal power supply unit of the control unit can adjust automatically
between 110 V and 240 V.
8. Switch on the MCW-D 100 with the On/Off-switch (8) on the rear. The Power LED (1) on the front will illuminate green.
9. Depending on the configuration of the MCW-D 100 control unit 5 or more channel-LEDs will illuminate green (standard: 5 channels).
10. When mounting the MCW-D 100 control unit into a 19"-rack housing leave 1 HU for a ventilation panel.
Note
•
If the system should fail to operate, i.e. the microphone unit is switched on but no sound is heard, press the reset button (3).
Should the system still fail to operate, please contact your beyerdynamic representative.
•
If you press the standby button (2) for more than 3 seconds, you switch off all switched-on MCW-D microphone units within the range
of the MCW-D 100 control unit.
Safety Information
•
Never expose the unit to water or excessive humidity. Do not install near swimming pools, spas, in a wet basement or in other
excessively humid environments.
•
Never pour any liquids into the unit.
•
Do not install or use this unit near sources of high heat, such as radiators, heat registers, flood lamps, spotlights, stoves, or other
appliances.
•
Always route cables running to the unit where they will not be pinched or cut by heavy or sharp objects.
•
Always turn off the power to the amplifier when making input or output connections.
•
Verify that the voltage rating of the unit matches that of the AC mains outlet you are to use. If you connect the unit to the wrong
voltage, you may seriously damage it.
•
Do not put wires or small objects through any of the ventilation grilles. Electric shock may result.
•
This unit needs a sufficient ventilation. Therefore, never cover the ventilation grilles.
•
Never place burning objects onto the unit.
23
Werbung
Inhaltsverzeichnis
