Cartridge Replacement - Crosley C6C Bedienungsanleitung

English
Turntable Operation
Press the Power Switch to turn on the power.
1.
Set the Speed Switch accordingly.
2.
Place the record on the turntable. Use the 45 RPM Adapter if necessary.
3.
Remove the stylus protector from the stylus assembly.
4.
Note: To avoid stylus damage, make certain the included stylus guard is in place
whenever the turntable is being moved or cleaned.
Release the Tonearm Clip.
5.
Note: when the turntable is not in use, remember to lock the Tonearm clip.
Use the Cue Lever to lift the tonearm.
6.
Gently move the tonearm over the record where play is desired to begin. Set the Cue
7.
Lever back to the down position. The tonearm will descend slowly onto the record and
begin to playback.
When the record is finished playing, use the Cue Lever again to raise the tonearm and
8.
then return it to the Tonearm Rest. Release the lever to let the tonearm sit back at its
rest. To suspend the playback, repeat the same steps.
Lock the Tonearm Clip to secure the tonearm.
9.
Anti-Skate Adjustment
• A small outward "anti-skating" force can be applied to the tone arm to compensate for the "skating" force that pulls the
arm toward the center of the record.
• For best performance during normal turntable usage, it is recommended to set the anti-skate control knob to the same
value as indicated by the downforce scale dial.

Cartridge Replacement

1. Before replacement, put the stylus protector back on the stylus to prevent damage to the stylus during the
replacement process.
2. Carefully remove the wire leads from the original cartridge.
3. Loosen the two screws on the headshell that are securing the cartridge and then remove the original cartridge.
4. Mount the new cartridge to the headshell and tighten it lightly. Do not completely tighten the screws at this moment.
5. Connect the wire leads to the new cartridge's terminals .The wire lead color codes are as below:
White Left channel positive
Black Left channel negative
Red Right channel positive
Black Right channel negative
6. Adjust the cartridge's position to make sure it is precisely aligned on the headshell so that the stylus will be tracking
the grooves in parallel perfectly.
To achieve this, place the included paper cartridge alignment protractor over the turntable spindle, carefully lift the
tone arm and place the tip of the stylus on the points marked 130mm and 250mm respectively. Fine tune the
cartridge's position on the headshell until the cartridge is perfectly in parallel with the reference lines at both points.
7. Tighten the screws completely once the perfect alignment is achieved.
(L+)
(L–)
(R+)
(R-)
6