Siemens EQ300 TF30-Serie Gebrauchsanleitung Seite 58

en Troubleshooting
Fault
Display shows "Close
door" despite the fact
that the door is
closed.
Display shows "Empty
trays" despite the fact
that the drip tray is
empty.
Display shows "Fill
water tank" and LEDs
flashing.
Display shows "Device
too cold".
Display shows "Re-
start appliance".
LEDs flashing.
Display shows "Re-
start appliance".
No LED is lit.
Display shows "Clean/
fill water tank";
and
light up.
58
Cause and troubleshooting
Door is not properly closed.
Press the door firmly shut.
▶
Appliance is too hot.
Disconnect the appliance from the mains.
1.
Wait 1 hour so the appliance can cool down.
2.
Appliance is switched off and does not detect empty-
ing.
Switch the appliance on, and remove the drip tray.
1.
Re-insert the drip tray.
2.
Water tank is missing or wrongly inserted.
Insert the water tank correctly.
▶
Pipe system in the appliance is dry.
Fill the water tank with fresh, cold, non-carbonated
▶
water.
Air is in the water filter.
Immerse the water filter in water with the opening
1.
facing upwards until no more air bubbles escape.
Reinsert the filter.
2.
Ambient temperature is too cold.
Operate the appliance at temperatures over 5 °C.
▶
Brewing unit is heavily soiled or cannot be removed.
Restart the appliance.
▶
Clean the brewing unit.
▶
Appliance has a fault.
Restart the appliance.
▶
Descaling process has been interrupted.
Proceed as described in section
▶
→ "Resetting a service programme", Page 53.