Waeco AirConServiceCenter ASC1000 Bedienungsanleitung Seite 88

Service tasks
4. In order to check the zero points of the scales for the oils and the UV
additive, open the cover flap (20) on the left-hand side and discon-
nect the containers from the snap locks:
– Container for new oil (17)
– Container for UV additive (18)
– Container for used oil (19)
When the scales are relieved, press ENTER to confirm. The prompt
to take the container off the scales flashes.
Once you have set the zero point, the selection menu for the scales
appears again.
5. Return the containers to the operating positions.
Attach the containers for oil (17) and (19) and for the UV
additive (18) to the snap locks again and close the cover (20).
6. Press STOP twice to go to standby mode.
88
20
AirConServiceCenter
18
17
19
EN