GB
CAUTION!
▶
Do not install if water pressure exceeds 827 kPa. If your water pressure exceeds 827
kPa, you must install a pressure limiting valve. Contact a plumbing professional if you
are uncertain how to check your water pressure.
▶
Do not install where water hammer conditions may occur. If water hammer condi-
tions exist, you must install a water hammer arrester. Contact a plumbing profes-
sional if you are
▶
uncertain how to check for this condition.
▶
Do not install on hot water supply lines. The maximum operating water temperature
of this filter system is 37.8 °C.
▶
Protect filter from freezing. Drain filter when temperatures drop below 4.4 °C.
▶
The disposable filter cartridge MUST be replaced every 6 months, at the rated ca-
pacity or if a noticeable reduction in flow rate occurs.
▶
Where a backflow prevention device is installed on a water system, a device for con-
trolling pressure due to thermal expansion must be installed.
▶
Ensure all tubing and fittings are secure and free of leaks.
Replacing the water filter
The filter must be changed every 6 months or when the water filter indicator on the
control panel lights turns on or the water dispenser output decreases.
To purchase a replacement water filter:
- Use replacement cartridge: HRXWF,
- Visit your local dealer or distributor. For further assistance, visit our website at www.
haierspares.eu
Notice
▶
Replacing the water filter causes a small amount of water (around 1 oz. or 25 cc) to
drain.
▶
Wrap a cloth around the front end of the water filter cover to collect any leaking wa-
ter. Hold the water filter upright, once it is removed, to prevent any remaining water
from spilling out of the water filter.
1.
Uplift the water filter cover.
2.
Remove the disposable water filter.
3.
Replace with a new water filter. Insert the new filter into the filter head and rotate it
clockwise until the arrow on the new filter lines up with the arrow on the filter head.
Swing the filter back into the compartment.
4.
Close the water filter cover.
Use
27