Only use the original charger from
the package to charge the battery.
•
The device may only be powered
with SELV (Safety Extra Low Vol-
tage) as marked on the device.
•
Charge the battery before the first
time of use.
•
Always take heed of the applicable
safety instructions as well as the en-
vironmental protection regulations
and information.
•
The warranty excludes all defects
caused by improper handling.
Recharging the battery
1. Connect the charger plug to the
charging socket (
vice.
2. Plug the battery charger (
into a mains outlet.
3. When the battery is fully re-
charged unplug the battery
charger (
Red LED lights up
Green LEDs light up
Checking the battery charge
level
The battery's charge level is indicated by
the charge state indicator (
The state of charge of the battery is displa-
yed by illuminating the appropriate LED
lights. In order to activate the display, the
on/off switch (
9) must be pressed.
Green LED lights up
Battery fully charged
6) of the de-
11)
11) from the mains.
Battery charging
Battery fully
charged
5).
Red LED lights up
Battery needs to be charged
Starting up
Before the starting up must
the transport safety (
removed.
Open the transport safety (
ve the transport safety of the bit holder
(
3).
Operation
1. Direction switch
You can toggle between right and left ro-
tation by pushing the direction of rotation
switch (
8).
If you move the direction switch (
the middle position, the device is secured
against being switched on.
The direction changed may
only be performed in stand-
still mode!
2. Bit selection from the
bit changeable drum
Push the slide of the interchangeable cord-
less screwdriver (
B
Turn the bit changeable drum to the left or
right until the desired bit is located on top
and is in line with the bit holder (
bit changeable drum engages audibly.
Push the slide of the interchangeable cord-
less screwdriver (
B
GB
IE
1)
1) and remo-
8) to
4) forward.
3). The
4) to the back.
NI
11