Makita DFT041R Betriebsanleitung Seite 7

Status of
the LED indicator/beeper
LED indicator Beeper
Blinks in red
and yellow A long beep
alternatively.
Blinks in red
A series of
and blue
short beeps
alternatively.
011058
Note: These values can be changed on PC (except for DFT041R). Refer to SRCV02 USER MANUAL for details.
For LED#B (Fig. 6)
Led indicator / Beeper on the tool shows the following functions.
Description Viewed color
LED#B (1) Green
LED#B (2) Red
007929
Note 1: Refer to a instruction manual of receiver (acces-
sory) RCV02 when connecting it.
Note 2: Communication distance: 10 m or less (variable
up to 10 m depending on the operation environment)
CAUTION:
• Make sure that LED#B (2) does not light up before
removing a battery cartridge from the tool. If a battery
cartridge is removed while LED#B (2) lights up or
blinks, tools stored data will be deleted.
Function
Warning against Fastening is incomplete when switch
insufficient trigger of tool is released before clutch
fastening activation.
Double-hitting This function works when a screw is
detection refastened after fastening.
This function works when a screw is not
Angle judge NOK fastened within the angle range preset
on PC (Note).
This function works when a fastening is
Rundown NOK finished before it reaches the preset
angle range. (Note)
Torque impossible This function works when torque
monitoring monitoring is cannot be carried out.
Disconnection
Radio communication not yet
(when using
established
receiver RCV02)
Radio
This function works when there is radio
communication
communication failure.
failure
1 lights up
2 blinks
3 is turned off
1 lights up
2 blinks
3 is turned off
Status
View and status
when the tool is connected to a receiver.
when the tool is on the step of being connected to a
receiver. (Note 1)
one of the status below
3-1 when the battery cartridge is removed from the tool.
when the tool is left idle for more than 15 minutes
3-2
with a installed battery cartridge.
when the tool is not within the transmission dis-
3-3
tance. (Note 2)
when the tool's stored number of data reaches its storable
number of data.
when the tool's stored number of data is equal to or smaller
than its storable number of data.
when the tool has no stored data to transmit to a receiver.
Adjusting the fastening torque (Fig. 7 & 8)
When you wish to drive machine screws, wood screws,
hex bolts, etc. with the predetermined torque, adjusting
the fastening torque as follows.
1. First remove the battery cartridge from the tool.
2. Loosen and remove the screw that secures ring.
3. Rotate the ring in the front of the tool by hand so that a
hole can be seen below the ring.
Action to be taken
__
__
__
__
__
Finish necessary
connection or remove
a battery cartridge to
escape.
Take it to a Makita
Authorized Service
centers.
7