Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
b)
Only mild detergents designed for cleaning food contact surfaces may be used
to clean the unit.
c)
After each cleaning, all the parts should be dried well before the unit is used
again.
d)
Store the unit in a dry and cool place protected from moisture and direct
sunlight.
e)
Do not spray the unit with a stream of water or immerse it in water.
f)
Make sure that no water enters through the ventilation openings in the casing.
g)
Clean the ventilation openings with a brush and compressed air.
h)
Perform regular inspections of the unit checking technical fitness and any
damages.
i)
Use a soft cloth for cleaning.
j)
Do not use sharp and/or metal objects (e.g. a wire brush or metal spatula) for
cleaning, as these may damage the surface of the material from which the unit
is made.
k)
Do not clean the unit with acidic substances, medical products, diluent, fuel,
oil or other chemicals as this may cause damage to the unit.
DISPOSAL OF USED UNITS.
At the end of its useful life, this product should not be disposed of with normal
household waste but should be taken to a collection point for the recycling of
electrical and electronic equipment. This is indicated by the symbol on the
product, operating instructions or packaging. The materials used in this unit are
recyclable according to their marking. You will be making an important
contribution to protecting our environment by reusing, recycling or otherwise
disposing of used units.
Your local administration will provide you with information about the
appropriate disposal point for used units.
TROUBLESHOOTING
Problem
Occurrence of brown
stains on products
Sticking of products
to the tray
Food becomes moldy
/ moist
Possible cause
Drying temperature too
high
Failure to control and flip
products
Failure to carry out the
process correctly
Improper storage of
products
Action
Adjust the temperature
value to the food product.
Control the drying process
Turn the products over 2
hours after starting the
process.
Perform the process
according to the guidelines
Check the tightness of the
storage containers
Werbung
Inhaltsverzeichnis
