Herunterladen Inhalt Inhalt Diese Seite drucken

Disposal Of The Packaging; Setup; Setup Location Requirements; Feet - CASO DESIGN CASO BBQ Cooler L-R Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 12
► Only remove the blue protective film shortly before setting up the device in the location
where it will be used, to prevent scratches and dirt accumulations.

13.4 Disposal of the packaging

The packaging protects the device against damages during transit. The packaging
materials are selected in accordance with environmentally compatible and
recycling-related points of view and can therefore be recycled.
Returning the packaging back to the material loop saves raw materials and reduces the
quantities of accumulated waste. Take any packaging materials that are no longer required
to "Green Dot" recycling collection points for disposal.
► If possible, keep the original packaging for the device for the duration of the guarantee
period of the device, in order that the device can be re-packaged properly in the event
of a guarantee claim.

13.5 Setup

13.5.1

Setup location requirements:

In order to ensure the safe and trouble-free operation of the device, the setup location
must fulfil the following prerequisites:
 Place your appliance on a floor that is strong enough to support the appliance when it is
fully loaded.
 Locate the appliance away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight and heat sources may adversely affect energy
consumption and cooling performance.
 This cooling appliance is intended for ambient temperatures of 16–38 °C.
 The appliance is suitable for indoor and (protected!) outdoor use. Do not install the
appliance in a wet or very humid environment.The device complies with the
International protection rating IPX4. Protect the device from the weather conditions and
frost.
 The device requires an adequate flow of air in order to operate correctly. WARNING! Do
not close the ventilation openings in the device housing.
 The electrical socket must be easily accessible so that the power lead can be
disconnected easily, in the case of an emergency.
 The installation and assembly of this device in non-stationary setup locations (e.g. on
ships) must be carried out by specialist companies / electricians, provided they
guarantee the prerequisites for the safe use of this device.
 Installation in outdoor kitchens is possible, provided the requirements for the installation
location are met.
13.5.2

Feet

The unit is supplied with 3 long feet and one short foot. Align the feet so that the unit is
level and does not tilt.
Please note
Please note
33

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

697

Inhaltsverzeichnis