Lamp Replacement; Control Panel - afx light HOTBEAM-10R-PACK Bedienungsanleitung

the fuse.
If the fuse is broken, change it by the same value and same size fuse

LAMP REPLACEMENT

IMPORTANT: Disconnect the unit from the mains prior to opening the lamp compartment.
Don't touch the lamp with bare hands. If the lamp is hot, please wait at least 20 minutes to let it
cool down. Fasten the head with the Tilt lock in 60° position.
Remove the 2 screws on the rear panel
via a cross-headed screwdriver and re-
move the cover.
Keep the lamp holder in place with one
hand and pull out the wire and the lamp
with the other hand.
Once you have removed the lamp, clean
the inside part of the lens to get a brighter light output.
Push in the new lamp, place the wire inside the compartment and close the compartment with the
2 screws.
OPERATION

CONTROL PANEL

The LCD display shows you all information about moving head control
The wheel is used to select all menus and validate your settings.
Control wheel: turn right, left and press
CW rotation: increases the value
CCW rotation: decreases the value
MENU
• DMX address : Used to select DMX address
• Display :
- Showreve : Select display : Normal or reversed ( 180° )
- Language : To select language ( chineese or english )
- Brigsett : To set the brightness of the display ( between 00 and 255 )
- Backlight : To set the delay of the backlight ( either 60s, either backlight light always )
- MenuBack : to select the delay to main menu return ( either after 60s, either never )
- Backflash : DMX display indication ( either display blink when no DMX signal, either no blick )
- ▲: To return to previous menu
• Features :
- X / Y setup : Pan and Tilt setups
- Xreverse : Pan move ( normal or reversed )
- Yreverse : Tilt move ( normal or reversed )
- XY speed : Pan / tilt moves speed ( Fast, normal or slow )
- Angle Pan : 360°/ 540° / 630°
- XY Fback : Test Pan / Tilt
- ▲: To return to previous menu
- Shortcut : shortcut colors and gobos ( whithout ( Off ) or with ( Open ))
- Fullcolor : Display color on color wheel ( half color ( Off ) or Full color ( Open ))
- Chanmode : DMX mode select ( soit simple ( small 16 CH or normal( standard 24CH))
- Recemode : Operating mode select( DMX, wireless or auto )
www.afx-light.com
5 EN