Troubleshooting - Amprobe WT-10 Bedienungshandbuch

TROUBLESHOOTING

Power on but no display
Check the batteries are in place and making good
contact and correct polarity. Replace a new battery if
needed.
Slow response
Clean probe by immersing the electrode in tap water for
10-15 minutes, then thoroughly rinse with distilled water
or use a general purpose electrode cleaner.
- - - -
Out of pH range. Too acidic or too alkaline or the
electrode is not immersed in the water.
Fig 1.
Fig 3.
Fig 5
8
Fig 2.
Fig 4.