What To Do If - Progress PKG1640 Benutzerinformation

24 progress
4. When defrosting is completed, dry the in-
terior thoroughly and keep the scraper for
future use.
5. Switch on the appliance.
6. After two or three hours, reload the pre-
viously removed food into the compart-
ment.
Important! Never use sharp metal tools to
scrape off frost from the evaporator as you
could damage it.

What to do if...

Warning! Before troubleshooting,
disconnect the mains plug from the
mains socket.
Only a qualified electrician or competent
person must do the troubleshooting that
is not in this manual.
Problem
The appliance does not
operate. The lamp does
not operate.
The lamp does not work.
The compressor operates
continually.
8) If foreseen.
All manuals and user guides at all-guides.com
Possible cause
The appliance is switched off.
The mains plug is not connected
to the mains socket correctly.
The appliance has no power.
There is no voltage in the mains
socket.
The lamp is defective.
The temperature is not set cor-
rectly.
The door is not closed correctly.
The door has been opened too
frequently.
Do not use a mechanical device or any arti-
ficial means to speed up the thawing process
other than those recommended by the man-
ufacturer.
A temperature rise of the frozen food packs,
during defrosting, may shorten their safe
storage life.
Periods of non-operation
When the appliance is not in use for long pe-
riods, take the following precautions:
• disconnect the appliance from elec-
tricity supply
• remove all food
8)
• defrost
and clean the appliance and all
accessories
• leave the door/doors ajar to prevent un-
pleasant smells.
If the cabinet will be kept on, ask somebody
to check it once in a while to prevent the food
inside from spoiling in case of a power failure.
Important! There are some sounds during
normal use (compressor, refrigerant
circulation).
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical appli-
ance to the mains socket.
Contact a qualified electrician.
Refer to "Replacing the lamp".
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open longer
than necessary.
Solution