G&D VisionXS-IP-C-DP-UHR Installation Und Bedienung Seite 143

4. Select between the following values under
Primary slave:
Link monitoring:
MII down delay:
MII up delay:
ARP interval:
ARP validate:
ARP target:
5. Press F2 to save your settings.
Press F8 to select between the options.
Select whether data traffic should preferably be transmitted
via the interface Transmission 1
As soon as the selected interface is available, this interface is
used for data traffic.
If you select the option
interface. A switch-over occurs only if the active interface
fails.
Press F8 to select between the options.
Select whether you want to use the
explanation above) to monitor the interface.
Waiting period in milliseconds before a failed network inter-
face is disabled.
The entered value must be a multiple of 100 ms (the MII link
monitoring frequency).
Waiting period in milliseconds before a reset network inter-
face is activated.
The entered value must be a multiple of 100 ms (the MII link
monitoring frequency).
Enter the interval (100 to 10,000 milliseconds) after which
the system checks for incoming ARP packets of the network
interfaces.
The validation ensures that the ARP packet for a particular
network interface has been generated by one of the specified
ARP targets.
Select whether or which of the incoming ARP packets
should be validated. Press
 None: ARP packets are not validated (default).
Only the ARP packets of the active network inter-
 Active:
face are validated.
 Backup: Only the ARP packets of the inactive network
interface are validated
The ARP packets of all network interfaces of the group
 All:
are validated.
The table contains a list of all configured ARP targets.
Use the buttons F3: Add
ARP targets.
Initial configuration of the network settings
:
Parameter
or the interface
, the data traffic is sent via any
None
MII or the
F8 to select between the options.
, F4: Delete and F5: Edit to manage the
G&D VisionXS-IP-C-DP-UHR · 24
Transmission 2 .
ARP mode (see