Motor Protection; Technical Data; Disposal Notes - Olympia PS 24 CCD Bedienungsanleitung

Clearing a jam
If too much material is inserted in the respective cutting unit, it will cause a jam.
Proceed as follows:
Push the sliding switch to the REV position.
-
The cutting unit runs backwards and pushes the excess material back.
-
Reduce the quantity and slide the switch to AUTO again. The cutting unit runs
-
forward again and the residue remaining is shredded.
If the backwards and forwards movement does not remedy the jam, pull out the mains
plug and remove the remaining manually from the cutting unit.

Motor protection

The motor switches off automatically in the event of overloading. Pull out the mains
plug from the socket and allow the motor to cool down to room temperature. Plug the
mains cable back in and then continue operation.
Notes on care and maintenance
Caution: maintenance work may only be performed when the mains plug is pulled
out.
To ensure your shredder enjoys a long working life, we recommend to clear residual
material from the cutting units at regular intervals and apply special oil for paper
shredders to the cutting unit. This special oil is available from specialist dealers or di-rectly
from our service centre in Hattingen. This will extend the service life of the device.

Technical data

Model:
Cutting width of the paper slot:
Cutting width of the CD slot:
Cutting power:
Security level:
Power supply:
Max. power consumption:
Rated operation:
Size (W x H x D):
Weight:
Paper basket:
CD basket:
PS 24 CCD
220 mm, size of the cuttings: 4 x 45 mm
123 mm, width of cut strips: 22 mm
2
7 DIN A4 sheets (70 g/m ), 1 CD, 1 credit card
3
230V / 50Hz
1,2 A
2 min. on, 20 min. off
342 x 138 x 380 mm
11,3 kg
12 litre
0,6 litre
Device malfunctions
Problem Cause
Device does not Is the mains cable plugged
work properly in the socket?
Is the sliding switch set to
AUTO?
Does the motor not start
when paper, CD or credit
card is inserted?
Device does not Was the device in constant
work after lengthy operation for some time?
operation or Is the surface of the device
stops during warm?
operation
Jam Have you inserted more
than 7 sheets of paper (70
g/m²), more than 1 CD or
more than 1 credit card?
Has the material not been
inserted straight in the in-
feed slot?
If you cannot rectify the fault yourself, contact your dealer or call the Olympia hotline.

Disposal Notes

This symbol [the crossed-out wheeled bin/PICTURE] means that the product should
be brought to the return and or separate collection systems available to end-users,
when the product has reached the end of its lifetime. This symbol applies only to the
countries within the EEA (*).
(*) EEA = European Economic Area, which comprises the EU Member
States plus Norway, Iceland, and Liechtenstein.
Remedy
Plug the mains cable into the
socket properly.
Set the sliding switch to AUTO.
Slide the paper, CD or credit card
in the respective slot so that it
touches the sensor in the centre.
Pull out the mains plug from the
socket and allow the motor to cool
down to room temperature.
Set the sliding switch to REV to
push back the material. Switch the
device to AUTO again to shred the
material remaining in the cutting
unit.