Emergency Stop; Switching The Device Off; Indicator Elements; Motor Protection - Olympia ECS 408.2 CCD Bedienungsanleitung

5.4 Shredding CDs, DVDs or credit cards
Only insert 1 CD, DVD or credit card at a time for the shredding process.
Note:
1. The device is switched on and the ECS function is activated.
2. Insert the CD, DVD or credit card in the CD infeed.
If, for security reasons, you want to shred credit cards using particle-cut
Note:
(cross-cut), you can also feed credit cards into the shredder's paper infeed.
This only applies for credit cards and not for CDs/DVDs!
5.5

Emergency stop

If the ECS function is activated or forward or reverse operation are on, you can stop the
device in an emergency situation by pressing the ECS button.
5.6

Switching the device off

Set the On/Off switch to its OFF position.
6

Indicator Elements

Indicator Cause
Device is ON
Overloading
(material jam)
Motor has
overheated
Waste bin full
7

Motor Protection

The motor switches off automatically in the event of an overload. The red "motor
overheated" lamp lights up in this case.
1. First of all, disconnect the power plug from the power socket and allow the motor to
cool down to room temperature.
2. Then connect the power plug to the power socket again and continue operation.
Observe the operating cycle stipulated in Chapter "Technical Data".
Note:
Solution
Clear the material jam, refer to Chapter
"Clearing a material jam". Observe the
recommended capacities regarding the
material to be shred stipulated in Chapter
"Technical Data".
Let the motor cool down, refer to Chapter
"Motor Protection". Observe the operating
cycle described in Chapter "Technical Data".
The waste bin is full and must be emptied,
refer to Chapter "Emptying the waste bin".
21