Troubleshooting - Wilfa ICM1-600 Anleitung

TROUBLESHOOTING

1. Please note, if a power failure occurs due to disconnection of the power cord,
or the power button has been pushed off during an ice making cycle, small
pieces of ice formed and lodge in the automatic shovel causing it to jam. If
this occurs, the ice cubes can be removed by disconnecting the power cord
and gently pushing the shovel to the rear of the cabinet and removing the ice
cubes, then restarting.
2. Please check if the water container is flat when the ice shovel can not remove
the ice to ice collecting tray. If not, please push the ice shovel gently by finger,
then press START/PAUSE button to restart.
Problem
The ice maker
does not start
The compressor
works abnormally
with a buzzing
noise
"Ice Full" is on
Water shortage
light is on
The ice made is
too large and with
pieces sticking
together.
The ice making
process was
correct, but no ice
came out?
ICM1-600 · GLACIER
Possible reasons
The ice maker is not
plugged in
The voltage is lower
than recommended
The ice basket is full
1. There is no water
2. The pump is full of air
Ice of previous cycles
left in the water tray
1. The compressor has
no refrigerant
2. Compressor damaged
3. Fan motor damaged
11
Solutions
Plug in the power cord
Stop the ice maker and do
not restart until the voltage is
normal.
Remove ice from the ice
basket
1. Add some water until it
reaches MAX line
2. Press START/PAUSE button
to restart the machine
Take out the ice under the
standby state
Contact the supplier
EN