Before First Use - Electrolux GA60SLVS Benutzerinformation

18 www.electrolux.com
If the credentials are not
entered, the dishwasher
deactivates the wireless
connection after some time.
If the connection is successful, the
dishwasher displays Connection
successful. Refer to "Daily use"
chapter to activate remote start.
If the connection is
unsuccessful or the display
shows Updating, refer to
"Troubleshooting".
If you want to cancel the procedure,
press any active button and confirm the
cancellation. Alternatively, deactivate
and activate the appliance.
8.2 How to deactivate the
wireless connection
Enter setting mode, select the setting
WiFi and change its value to OFF.

9. BEFORE FIRST USE

1. Make sure that the current level of
the water softener agrees with the
hardness of the water supply. If
not, adjust the level of the water
softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start the programme Quick to
remove any residuals from the
manufacturing process. Do not use
detergent and do not put dishes in
the baskets.
After starting the programme, the
appliance recharges the resin in the
water softener for up to 5 minutes. The
washing phase starts only after this
procedure is complete. The procedure is
repeated periodically.
9.1 The salt container
CAUTION!
Use rough salt designed for
dishwashers only. Fine salt
increases the risk of
corrosion.
8.3 How to activate the wireless
connection
Enter setting mode, select the setting
WiFi and change its value to ON.
Refer to "Daily use" to activate the
remote start.
8.4 How to reset the network
credentials
If you want to connect to a different
wireless network or update the
credentials of the current network, reset
the network credentials.
Enter setting mode and activate the
setting Forget network.
The indicator is off.
Connect the dishwasher to the network
and to the app to enter new network
credentials. Refer to the instructions
provided earlier in this chapter.
The salt is used to recharge the resin in
the water softener and to assure good
washing results in daily use.
How to fill the salt container
1. Turn the cap of the salt container
counterclockwise and remove it.
2. Put 1 litre of water in the salt
container (only for the first time).
3. Fill the salt container with dishwasher
salt (until it is full).
4. Carefully shake the funnel by its
handle to get the last granules inside.
5. Remove the salt around the opening
of the salt container.