Function Setting - Mitsubishi Electric Mr. SLIM PSA-M KA-Serie Bedienungshandbuch

4. Function Setting

Function selection of remote controller
The setting of the following remote controller functions can be changed. Change the setting when needed.
Depending on the function, an administrator password or maintenance password may be required at the time of setting.
The default for the administrator password is "0000", and "9999" for the maintenance password.
For setting passwords, refer to the Installation Manual.
Main menu Setting items
Operation High power **
Timer Timer On/Off timer*
Auto-Off timer
Weekly timer*
OU silent mode**
Night setback*
Energy Restriction Temp. range
saving
Operation locked
Energy Auto return
saving
Schedule*
Initial setting Basic setting Clock
Daylight saving time
Display Main display
setting
Black and white
inversion setting
Contrast
Brightness
Language selection
Service Initialize remote controller
Remote controller information
Maintenance Error information
Filter information
*: Clock setting is required.
**: This function can only be set when certain outdoor units are connected.
Use to reach the comfortable room temperature quickly**.
• Units can be operated in the High-power mode for up to 30 minutes.
Use to set the operation On/Off times.
• Time can be set in 5-minute increments.
* Clock setting is required.
Use to set the Auto-Off time.
• Time can be set to a value from 30 to 240 in 10-minute increments.
Use to set the weekly operation On/Off times.
• Up to eight operation patterns can be set for each day.
• Two types of weekly schedules can be set.
* Clock setting is required.
* Not valid when the On/Off timer is enabled.
* 1ºC increments
Use to set the time periods in which priority is given to quiet operation of outdoor units over temperature
control. Set the Start/Stop times for each day of the week.
• Select the desired silent level from "Normal," "Middle," and "Quiet."
* Clock setting is required.
Use to make Night setback settings.
• Select "Yes" to enable the setting, and "No" to disable the setting. The temperature range and the start/
stop times can be set.
* Clock setting is required.
* 1ºC increments
Use to restrict the preset temperature range.
• Different temperature ranges can be set for different operation modes.
* 1ºC increments
Use to lock selected functions.
• The locked functions cannot be operated.
Use to get the units to operate at the preset temperature after performing energy-save operation for a
specified time period.
• Time can be set to a value from 30 and 120 in 10-minute increments.
* This function will not be valid when the preset temperature ranges are restricted.
* 1ºC increments
Set the start/stop times to operate the units in the energy-save mode for each day of the week, and set
the energy-saving rate.
• Up to four energy-save operation patterns can be set for each day.
• Time can be set in 5-minute increments.
• Energy-saving rate can be set to a value from 0% and 50 to 90% in 10% increments.
* Clock setting is required.
Use to set the current time.
Sets the daylight saving time.
Use to switch between "Full" and "Basic" modes for the Status display and the Main display.
• The default setting is "Full."
Use to invert the colors of the display, turning white background to black and black characters to white.
Use to adjust screen contrast and brightness.
•
Use to select the desired language.
Use to initialize the remote controller to the factory shipment status.
Use to display the remote controller model name, software version, and serial number.
Use to check error information when an error occurs.
• Error code, error source, refrigerant address, unit model, manufacturing number, contact information
(dealer's phone number) can be displayed.
* The unit model, manufacturing number, and contact information need to be registered in advance to be
displayed.
Use to check the filter status.
• The filter sign can be reset.
Setting details
en
7