Connection; Connecting The Inpro 6800 To A Cable; Connecting The Vp Or Ak9 Cable To The Transmitter - Mettler Toledo InPro 6800 Serie Bedienungsanleitung

20
4.2

Connection

4.2.1 Connecting the InPro 6800 to a cable

h
Sensors with ISM functionality require the use of a
special AK9 cable as well as an ISM compatible O
transmitter. The sensor is connected to the transmitter
via a AK9 cable. The AK9 cable ensures a secure con-
nection between the transmitter and the sensor under
harsh industrial conditions. The robust watertight IP68
connector housing guarantees maximum process
safety. If you have chosen to use a sensor with digital
ISM functionality, the K8S connector will incorporate a
preamplifier. It is absolutely necessary to protect this
electronic component against any electrical charge
a
Do not touch the sensor at the VP connector plug.
.
To connect the VP cable to the sensor align the slit of
the VP connector with the pin in the plug. Then tightly
screw the plug to fasten the two parts.

4.2.2 Connecting the VP or AK9 cable to the transmitter

h
Note: Cable assignment can be found in the METTLER
TOLEDO VP cable instruction manual.
h
Note: For connecting the cable to the terminals of the
transmitter, please refer to the instructions given in the
METTLER TOLEDO transmitter manual.
InPro 6800
52 200 953 C
InPro 6800 O
VP-6 cable for standard use
VP-8 cable for ISM functionality
Plug
Pin
Slit
VP connector K8S connector
for digital ISM
© 02 / 2023 METTLER TOLEDO
Sensor 12/25 mm
2
O Transmitter
2
VP or AK9 cable
Printed in Switzerland
2