Device Maintenance - Red Sea ReefRun Dual Controller Benutzerhandbuch

Red Sea ReefRun ® Dual Controller
Clear settings
To permanently remove all user settings from the memory of the
ReefMat and return it to its initial default state, perform the following
steps.
If the device is connected to the ReefBeat, trigger the hard-reset option
from the Device-Manager: Device Manager>Hard-Reset
If the device is not connected to the ReefBeat, press the Settings button
for about 15 seconds (until the Wi-Fi indicator LED shows a double blink),
release the button and wait for about 1 minute for the device to reboot.
The unit will restart without any user settings and with the Wi-Fi in AP
mode, exactly as shipped from the factory. The unit will retain the latest
installed version of the firmware.

Device Maintenance

RRDC
For continued smooth running of the RRDC, we recommended making
sure that it is kept clean, dry, and free of any buildup of salt deposits on
a regular basis.
The unit is not waterproof. Do not submerge in water or other solutions.
Back-up battery
The RRDC has a back-up battery to maintain the correct time when
the unit is disconnected from the power supply. This battery will need
to be replaced once every few years. To replace the battery, unscrew
the 4 screws on the back of the controller and remove the back cover.
Replace with a new 3V Lithium cell Battery CR1220 reassemble the back
cover and tighten the 4 screws back into place. After reassembling the
18
unit and switching it on, the internal time will be reset as soon as the
internet connection is restored.
The battery is being monitored and you will be advised through the
ReefBeat App when the battery needs replacing
Skim sensor
Make sure that the sensor is kept free of any buildup of organic
waste, algae growth, or salt deposits on a regular basis. The sensor is
waterproof and can be safely washed under running water. The titanium
tips can be brushed to remove any hard deposits.
It is recommended to rinse the sensor tips in the sump once a week as
part of your regular cup maintenance. Before rinsing, switch the self-
leveling function off to avoid triggering the self-levelling / full-cup. If
you did not switch off before rinsing you will need to "resume" normal
skimming from the App.
Pumps
The pumps and impellors are susceptible to the buildup of calcium
carbonate deposits that over time will affect the performance and
should be cleaned about once a month. Refer to the ReefRun pump / DC
Skimmer manual for correct maintenance.