Electrolux DMGL8372UO Benutzerinformation Seite 22

22 www.electrolux.com
one.
WARNING!
Make sure you do not let
water get inside the hood.
If water or other liquids spill inside the
hood system:
• switch off the hood in the first place,
• lift the grid and clean the hood area
carefully with a moist cloth or sponge
and a mild cleaning agent,
• wipe away the excess liquid gathered
on the bottom of the hood cavity using
a sponge or a dry cloth,
• switch on the hood, set the fan speed
level to 2 or higher and let it run for
some time to get rid of the remaining
moisture.
9.4 Cleaning the hood filter
The filter prevents grease particles from
getting into the hood system. The hob
has a built-in counter that reminds you
about cleaning the filter. After 100 hours
of use the filter indicator
blinking to signal that it is time to clean
the filter. The notification stays on for 30
seconds after you deactivate the hood
and the hob. The notification does not
block the use of the hob.
It is recommended to clean
the filter before the indicator
appears.
1. Remove the filter and filter housing
carefully. They are located right
under the grid in the centre of the
hob.
2. Clean the hood cavity with a cleaning
starts
3. Wash the filter and filter housing
4. Dry the filter for 7 minutes in an oven
5. Fix the filter and filter housing back in
6. Reset the counter.
Resetting the counter when the filter
indicator is on:
1. Clean the filter first and place it back
foam.
manually in warm water without using
detergents or abrasive sponges. You
can also wash them in a dishwasher
with the maximum temperature of
65-70 °C, without detergents and
without dishes in the same load. Only
the plastic parts can be cleaned
using detergents.
with the maximum temperature of
60°C or in an ambient temperature.
place when they are fully dried.
inside the hood.