JAROLIFT TDRCT04W Original Bedienungsanleitung Seite 22

PROGRAMMING
ADD / COPY WALL TRANSMITTER - TDRCT04W
The example shown is exemplary and depends on the respective receiver type. Please follow the instructions of the
receiver!
For details, please refer to the respective instructions for the TDEF radio motors and TDR radio receivers. NOTE!
The TDEF radio motors and the external TDR receivers can be controlled with several handheld and wall trans-
mitters. This enables, for example, individual and group control of the motor with a TDRCT04W
as well as simultaneous group and individual control with another hand-held or wall-mounted transmitter
(e.g. TDRC01 or TDRC01W).
To teach-in additional hand-held or wall transmitters to a radio motor or radio receiver, you need a hand-held or wall transmit-
ter that has already been taught-in (see "Initial programming").
Programming Example - Adding a TDRC08W
1. Select a taught-in channel on a transmitter that has already been taught in.
2. Select a desired channel on the new transmitter to be learned.
3. Press the UP and DOWN buttons simultaneously on the transmitter that has already been tuned in.
4. Then press the STOP button 8 times - also on the already taught-in transmitter.
5. The motor will vibrate briefly to confirm.
6. Within 10 seconds, press the UP and DOWN buttons simultaneously on the new transmitter to be learned.
7. Then briefly press the STOP button on the transmitter to be reprogrammed.
The engine will vibrate again briefly to confirm. The wall transmitter code has been copied to the new transmitter.
copied to the new transmitter.
Transmitter already taught-
in:
Mo
1 2 3 4
A taught-in chan-
nel with the K3
button.
M
Engine vibrates.
22
New transmitter to be
taught:
Mo
1 2 3 4
Select the desired
channel with the K3
button.
New transmitter to be
taught:
Mo
1 2 3 4
Up and down but-
ton simultaneous-
ly press.
Transmitter already taught-
in:
Mo
1 2 3 4
Up and down but-
ton simultaneous-
ly press.
New transmitter to be
taught:
Mo
1 2 3 4
Stop - Press the
key.
Transmitter already taught-
in:
Mo
1 2 3 4
Press the stop
button 8 times.
M
Engine vibrates.