Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
OIL
•
To maintain your clipper in peak condition,the blades should be
olled every few haircuts.
•
Do not use hair oil,grease oil mixed with kerosene or any solvent.
As the solvent will evaporate and leave the thick oil which may
slow down the blades motion.
BLADE LEVER
•
The lever is conveniently located near your thumb(if you're right-handed)so it can easily be
adjusted while the clipper is in your hand.
•
The lever adds versatility to your clipper by allowing you to gradually change the closeness of
your cut without an attachment comb.
•
When the lever is in the uppermost positionthe blades will give you the closest cut and leave
the hair very short.Pushing the lever downward graduallyincreases the cutting length.
•
In its lowest position,the lever will leave the hair approximately the same length as a #1 comb.
•
The lever will also extend the use of your blades since a different cutting edge is used in each setting.
•
In addition, if extremely heavy hair cutting has jammed the bladesit will help you remove hair that has
become wedged between the two blades without removing the blades.
•
While the clipper is running, rapidly move the lever form "close cut"
to "longer cut", a couple of times. Doing this each time after you have
finished using your clipper will help to keep the blades clear of cut hair if
your clipper stops cutting and this does not helpyour cutting blades are
dulled Replace them with new blades.
IMPORTANT SAFEGUARDS
When using electrical apliances, especially when children are present, basic safety precautions
should always be followed, including the following:
To reduce the risk of death or injury by electric shock:
• Unplug this appliance before cleaning.
• Do not place or store appliance where it can fall or be pulled into a tub or sink.
• Do not use while bathing or in a shower.
• Do not place in or drop into,water or other liquid.
• Do not reach for an appliance that has fallen into water. Unplug immediately to reduce the risk
of burns, electrocution, fire or injury to persons.
• Use this appliance only for its intended use as described in this manual. Do not use
attachments not recommended by the manufacturer.
• This appliance should never be left unattended when plugged in.
• Close supervision is necessary when this appliance is used by or near children or invalids.
• Never operate this appliance if it has a damaged cord or plug, if it is not working properly.
• Keep the cord away from heated surfaces.
• Do not pull, twist or wrap line cord around appliance.
• Never drop or insert any object into any opening on this appliance.
• Before use make certain blades are aligned properly.
• Do not place appliance on any surface while it is operating.
• Do not use this appliance with a damaged or broken comb nor with teeth missing from the
blades as injury may occur.
Close
Longer
Werbung
Inhaltsverzeichnis
